PSZ Series Shaping Machine is developed by our company. It is suit for crushing all kinds of rock material which compression strength less than 300 MPa into cubes. According to different needs, the rotor speed and the electrical power can be arbitrar chosen.Some parts of SCBL series can be remodeled into SX series easily.

       PSZ Series Sand Shaping Machine is composed of feeding pipe,shaft,rotor and motor.Air-cycle unit is assembled on two sides of feeding port,which can prevent dust from discharging outside.The rotor going round and round at a high speed produce less noise and vibration .Because we select special,life of the rotor is prolonged.

 

產品特點Features:
■優異的整形性能
■耐磨件數量少，使用壽命長，更換方便，運行成本低
■低噪音、低振動、粉塵少、符合要求
■     Excellent performance;
■     Longer life,lower cost;
■     Less noise,vibration and dust.

 

 

 

注：1、以上處理量是在抗壓強度為150-160MPa,堆密度為1.6t/m3,水分不大于1.5%的條件下得出。
2、給料均勻、連續。
3、上表所列是可以破碎物料的給料尺寸，但從破碎率和易損件的壽命考慮，希望提供< 40mm的物料。
Note:1.Above data is get under the condition that compression strength is 150-160 MPa and pile density is 1.6t/m3，and water content does not exceed 1.5%.

2.Feeding is continuous and even.